snmpcollector is not able to discover interfaces on cisco nexus
Article ID: 100122
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
- We created a profile for cisco nexus
- We are using SNMPv3 for the device.
- After discovery is finished, no interface components are visible in the probe GUI.
Environment
- snmpcollector 3.43
- target device is Cisco nexus
Cause
- If snmp v2 or v3 is used, we use 20 oids in a snmp bulk get request
- It caused cisco nexus to be too busy to respond to our snmp request
Resolution
1. Open snmpcollector probe in Raw Configure
2. Set the below key in the <setup> section
MAX_BATCH=3
3. Click Apply
4. Run "Force Component Rediscovery" for Cisco nexus profile.
Additional Information
Feedback
Yes
No
Powered by
