New CAL2DBVR program to report and fix data errors after converting to CA 7 r12/12.1
search cancel

New CAL2DBVR program to report and fix data errors after converting to CA 7 r12/12.1

book

Article ID: 9952

calendar_today

Updated On:

Products

CA 7 Workload Automation

Issue/Introduction

After converting to r12/12.1 if there are any data errors attempting to do CA 7 commands,  you can run the new CAL2DBVR program in CA07N610.  



Environment

Release:
Component: 7

Resolution

If any commands entered in CA 7 r12/12.1 have data issues, run the new DBVR (CAL2DBVR)  program.

Use member CA07N610 in hlq.JCLLIB to execute the new CAL2DBVR.  Run with the existing PARM='TRIG,RQMT,SCHD,XREF' which will report on any discrepancies found in the database.   CA7 online can be up and running when executing CA07N610.

To correct the errors found in the report, run the CAL2DBVR with the following PARM below.  Note that CA7 online must be down to make the updates.

PARM='TRIG,SCHD,RQMT,XREF,UPDT,DELR,DELT' 
-or- 
//DBVPARM DD * 
TRIG,SCHD,RQMT,XREF,UPDT,DELR,DELT 

The UPDT, DELR, and DELT PARMS will cause the CAL2DBVR program to 'fix' the issues found. You should then be able to bring up CA 7 r12/12.1 and retry the command without errors.